Jet
Amprobe - ACD-10 PLUS - Clamp On Digital Clamp Meter, 1 Jaw Capacity, CAT III 600V | Jet.com
Technical Specification Item Clamp Meter Digital/Analog Digital Clamp Meter Jaw Style Clamp On Max. AC Amps 600 Max. AC Volts 600 Max. DC Volts 600 Max. Ohms 40 megohm Jaw Capacity 1' Counts 4000 Battery Type CR2032 Safety Rating CAT III 600V AC Response TRMS Audible Continuity Yes Diode Test Yes Capacitance 3000uF Frequency Counter 5 Hz to 10 kHz Peak Hold Yes Display LCD Includes Test Leads, Battery (Installed), Soft Carrying Pouch, Users Manual Calibration Frequency 50 to 500 Hz Auto Ranging Yes Data Hold Yes Auto Power Off Yes AC Current Accuracy +/-2.0% + 5 Digits Operating Temp. 32 Degrees to 104 Degrees F Special Features Continuity Buzzer, Frequency Measurement, Autoranging, Overload Protected Manufacturers Warranty Length 1 yr. Compliance and Restrictions This item is restricted for international sale. This listing is for each. Display: 3-3/4 digits 4000 counts LCD display Update Rate: 3 per second nominal Polarity: Automatic Operating Temperature: °C to 40 °C < 80% RH for temperature up to 31 °C decreasing linearly to 50% RH at 40 °C Altitude: Operating below 2000m; Indoor use Storage Temperature: -20 °C to 60 °C, < 80% RH (with battery removed) Temperature Coefficient: nominal 0.15 x (specified accuracy)/°C @(0 °C ~ 18 °C or 28 °C ~ 40 °C) Low Battery: Below approx. 2.4V Power Supply: 3V coin battery IEC-CR2032 Power Consumption: 2.8 mA typical except that 3.3 mA typical for ACA function APO Timing: Idle for 30 minutes APO Consumption: 5 μA typical Jaw opening & Conductor diameter: max 26 mm Special Features: 30ms Max Hold Data Hold; Relative Zero mode Unit:Each Carton Quantity:1
See this content immediately after install